Kia Soul EV: Air Conditioning System / Refrigerant line Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Refrigerant line Repair procedures

Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
   
Cap the open fittings immediately to keep moisture or dirt out of the system.
3.
Tighten joint of bolt or nut to specified torque.
   
Connections should not be tightened to over the specified torque.
Items
N.m
kgf.m
lb-ft
Compressor
20.0 ~ 33.0
2.0 ~ 3.4
14.8 ~ 24.3
Accumulator mounting bolt
6.9 ~ 10.8
0.7 ~ 1.1
5.1 ~ 8.0
Discharge hose mounting bolt
Discharge pipe mounting bolt
Suction pipe mounting bolt
Suction hose mounting bolt
Tube & Hose assembly mounting bolt
Accumulator nut
7.8 ~ 11.8
0.8 ~ 1.2
5.8 ~ 8.7
Discharge hose nut
Discharge pipe nut
Suction pipe nut
Suction hose nut
Tube & Hose assembly nut
Refrigerant valve
9.8 ~ 11.8
1.0 ~ 1.2
7.2 ~ 8.7
Chiller (Refrigerant line)
5.9 ~ 9.8
0.6 ~ 1.0
4.3 ~ 7.2

4.
Evacuate air in the refrigeration system and charge system with refrigerant.

Specified amount
Without heat pump : 550 ± 25g (19.4 ± 0.88 oz.)
With heat pump : 900 ± 25g (31.7 ± 0.88 oz.)

5.
Inspect for leakage of refrigerant.
Using a gas leak detector, check for leakage of refrigerant.
6.
Inspect A/C operation.
Refrigerant line Components and Components Location
Component Location [Without Heat Pump] 1. Refrigerant line [With Heat Pump] 1. Refrigerant line ...

Electric A/C compressor Specifications
Specification ModelESC33nMotorBLDC MotorControl TypeCANCompression TypeScrollCapacity33cc/revOperating Voltage Range190~320VRated Voltage288VMount TypeBracket Mounting, 4 Point Mounting ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Center Pillar Trim Components and Components Location


Component Location 1. Center pillar lower trim2. Center pillar upper trim ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Blower Unit Components and Components Location


Component Location 1. Blower unit Components 1. High voltage PTC heater core2. Ionizer3. Evaporator temperature sensor4. Air inlet filter cover assembly5. Heater core pipe mounting bracket6. Heater - evaporator seal7. Intake duct case [LH]8. Intake arm9. Intake actuator motor assembly10. ...

Copyright © www.ksoulev.com 2020-2025