Kia Soul EV: High Voltage Battery Control System / Components and Components Location

Kia Soul EV (PS EV) 2015-2020 Service Manual / EV Battery System / High Voltage Battery Control System / Components and Components Location

Components Location
High Voltage Battery System Assembly

1. BMS ECU
2. Main Relay
3. Pre Charge Relay
4. Pre Charge Resistor
5. Battery Current Sensor
6. Safety Plug
7. Main Fuse
8. Battery Temperature Sensor
9. Runaway Arresting Device (RAD)
10. High Voltage Battery Heater (With heater system)
11. High Voltage Battery Heater Relay (With heater system)
12. High Voltage Battery Heater Fuse (With heater system)
13. High Voltage Battery Heater Temperature Sensor (With heater system)

1. BMS ECU
2. Main Relay
3. Pre Charge Relay

4. Pre Charge Resistor
5. Battery Current Sensor
6. Safety Plug

7. Main Fuse
8. Battery Temperature Sensor

9. Runaway Arresting Device (RAD)
10. High Voltage Battery Heater Temperature Sensor

11. High Voltage Battery Heater Fuse


Power Relay Assembly (Without heater system)

1. Main Relay (+)
2. Main Relay (-)
3. Pre Charge Relay
4. Pre Charge Resistor
5. Battery Current Sensor


Power Relay Assembly (With heater system)

1. Main Relay (+)
2. Main Relay (-)
3. Pre Charge Relay
4. Pre Charge Resistor
5. Battery Current Sensor
6. High Voltage Battery Heater Relay
7. High Voltage Battery Heater Fuse

High Voltage Battery Control System
...

Description and Operation
Description High Voltage Battery Control System High voltage battery control system consists of BMS ECU, PRA and it controls SOC (State of charge), output, trouble shooting, battery cell ba ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Inlet Temperature Sensor Description and Operation


Description Inlet temperature sensor is installed on the No.8 module of high voltage battery and it detects the inner air temperature of battery. The operation of cooling fan depends on the inlet temperature sensor value. Inlet Temperature Sensor Installation (on the No.8 battery modu ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Repair procedures


General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. Test conditionNormal ...

Copyright © www.ksoulev.com 2020-2024