Kia Soul EV: SRSCM / Front Impact Sensor (FIS) Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal

•	Removal of the airbag must be performed according to the precautions / procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable and wait for at least thirty seconds before beginning to work.

2.	Disconnect the front impact sensor connector (A).

3.	Loosen the mounting bolt and then remove the front impact sensor (B) and extension harness.

Installation

•	Do not turn the ignition switch ON nor connect the battery cable while replacing the front impact sensor.

1.	Install the new front impact sensor.

Tighten the front impact sensor (B) mounting bolt.

Tightening torque :

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)

3.	Connect the front impact sensor connector (A).

4.	Reconnect the battery negative cable.

After installing the Front Impact Sensor, confirm proper system operation:

•	Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS) Components and Components Location

Components ...

Side Impact Sensor (SIS) Description and Operation

Description Side Impact Sensor (SIS) system consists of two P-SIS, installed at each center of front door modules (LH and RH), and two SIS, installed at each center of nearby pillars (LH and RH ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Washer Motor Repair procedures

Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter. 2. Remove the fro ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Side Sill Moulding Repair procedures

Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Ta ...