Kia Soul EV: Crash Pad / Glove Box Housing Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

2.	Loosen the glove box housing mounting bolts (A).

3.	After loosening the mounting screws, remove the crash pad lower panel (A) using a screw driver.

4.	Disconnect the glove box lamp connector (A).

Remove the glove box housing mounting clip (A).

•	When installing glove box housing, be sure to insert lock pin (A) into wiring tape (B).

Install in the reverse order of removal.

•	Make sure that the connectors are connected properly.

•	Replace any damaged clips.

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

Steering Column Shroud Panel Components and Components Location

Component Location 1. Steering column shroud lower panel2. Steering column shroud upper panel ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: High voltage joint box Components and Components Location

Components Location 1. High voltage joint box2. Air conditioning compressor high voltage connector3. Electric power control unit (EPCU) high voltage cable4. On-board charger (OBC) high voltage cable connector5. PTC heater high voltage cable6. High voltage battery assembly high voltage cable7. H ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Main Crash Pad Assembly Components and Components Location

Component Location 1. Main crash pad assembly ...