Kia Soul EV: Lighting System / License Plate Lamps Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Lighting System / License Plate Lamps Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license plate lamp assembly (A).

3.
Replace the bulb (B) after removing the license plate lamp (A).

Installation
1.
Install the bulb.
2.
Install the license plate lamp assembly.
Fog Lamps Repair procedures
Inspection Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the following terminals. If continuity is not as specified, replace the multi ...

High Mounted Stop Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the high mounted stop lamp trim (A). 3. Detach the high mounted stop lamp (A) from the tailgate after loosening the mount ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Troubleshooting


Troubleshooting Vehicle inspection SYMPTOM CHART SymptomSuspect AreaRemedy (See page)Squeak or grunt-noise from the front suspension, occurs more in cold ambient temperatures-more noticeable over rough roads or when turningFront stabilizer barUnder these conditions, the noise is acceptabl ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Receiver-Drier Repair procedures


Replacement [Without Heat Pump] 1. Remove the condenser, and then use an L wrench to remove the bottom cap (B) from the condenser. Tightening torque : 9.8 ~ 14.9 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 2. Remove the desiccant (A) from the condenser using a long nose plier. Che ...

Copyright © www.ksoulev.com 2020-2025