Inspection |
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
2. |
Remove the front door module.
(Refer to Body - "Front Door Module") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily.
[Central Lock] |
5. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim") |
2. |
Remove the rear door module.
(Refer to Body - "Rear Door Module") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily.
[Central Lock] |
5. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim") |
2. |
Disconnect the 4P connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim") |
2. |
Disconnect the connector from the actuator. |
3. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Disconnect the connector (A) and bolts from the hood switch. |
2. |
Check for continuity between the terminals and ground according to the table. |