Kia Soul EV: Lighting System / Rheostat Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Lighting System / Rheostat Repair procedures

Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the lower crash pad switch assembly (A) by pushing it.

4.
Disconnect the connectors (A) from the lower crash pad switch assembly.

5.
Remove the rheostat switch (A).

6.
Check for intensity of rheostat switch. If the light intensity of the lamps changes smoothly without any flickering when the rheostat is turned on, it can be assumed that the rheostat is operating normally.

Hazard Lamp Switch Repair procedures
Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will be able to quickly diagnose defects ...

Fog Lamps Repair procedures
Inspection Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the following terminals. If continuity is not as specified, replace the multi ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: General Information


Basic Service Symbols There are five primary symbols used to complement illustrations. These symbols indicate that particular materials should be applied in each part during the sevice. SymbolMeaningDo not reuse the part. Replace a new one.Apply engine oil or transmission oil to the part. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Door Outside Handle Repair procedures


Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the hole plug (A). 3. After loosening the mounting bolt, remove the rear door outside handle cover (B). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Remove ...

Copyright © www.ksoulev.com 2020-2025