Kia Soul EV: Panorama Sunroof / Roller Blind Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Roller Blind Repair procedures

Removal

Open the roller blind using the panorama sunroof switch.

•	Leave 10 ~ 20cm (0.3937 ~ 0.7874 in) of the roller blind unopened.

2.	Remove the roof trim. (Refer to Roof Trim - "Roof Trim Assembly")

3.	Remove the roller blind bar (C) by pressing the top part of the lock pin (B) located on the both sides of the roller blind shoe (A).

4.	Put a fixed pin (B) into the hole located inside the groove of the right side roller blind side bracket (A). Becareful not to release tension.

5.	Remove the roller blind lower support (A) by loosening the mounting screws.

Installation

1.	Install the roller blind side bracket (A) fit into the guide groove (B).

2.	Tighten the mounting screws after installing the roller blind lower support (A).

3.	Remove the fixed pin (B) located inside the right side roller blind side bracket (A).

4.	Install the roller blind bar (A) on top of the roller blind shoe (B).

5.	Put the roller blind bar (A) into the roller blind shoe (B).

6.	Install the roof trim.

Completely close the movable glass using the panorama sunroof switch.

•	Roller blind tension adjustment

(1)	Put a fixed pin (B) into the hole located inside the groove of the right side roller blind side bracket (A). Becareful not to release tension.

(2)	Remove the roller blind lower support.

(3)	Press the lock pin (A) and then remove the push the roller blind (B) in the direction of the arrow.

(4)	Remove the roller blind (A) from the roller blind support bracket (B).

(5)

Remove the fixed pin (B) from inside the groove of the right side roller blind side bracket (A).

•	Be careful not to injure your hand when the roller blind side bracket tension gets releases.

(6)

Rotate the roller fabric (B) while holding the roller fabric side bracket (A).

•	Be careful not to injure your hand when the roller blind side bracket tension gets releases.

•	Rotate it 12 times clockwise.

(7)	Put a fixed pin (B) into the hole located inside the groove of the right side roller blind side bracket (A). Becareful not to release tension.

(8)	Install the roller blind on the roller blind support bracket.

Panorama Sunroof Deflector Repair procedures

Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Loosen he mounting screws (A) located at the side of the panorama sunroof deflector. ...

Panorama Sunroof Assembly Repair procedures

Removal • In order to remove the panorama sunroof assembly, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire g ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Battery Current Sensor Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Shut off the high voltage. (Refer to Battery Control System - "High Voltage Shut-off Prcedure") 3. Remove the high voltage battery system assembly. (Refer to High Voltage Battery System - Repair procedures - "Removal") 4. Remove the hi ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Auto Light Sensor Repair procedures

Inspection In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor''s input. During IGN1 ON, the BCM monitors the range of this supply and alerts the f ...