Kia Soul EV: Front Door / Front Door Latch Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch Repair procedures

Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

3.
Remove the front door outside handle connector wiring harness (A).

4.
Remove the front door outside handle cable (A).

5.
To remove the front door outside handle base connector (A), turn it counter clockwise and pull it forward.

6.
Remove the front door outside handle connector wiring harness (A).

7.
Disconnect the front door latch connector (A).
8.
Remove the front door latch assembly (B) by pulling it in the direction of the arrow.

9.
Remove the front door inside handle cage (A).

10.
Remove the front door inside handle cable (A) by pushing it backward.

11.
Install in the reverse order of removal.
   
Make sure that the connectors are connected properly.
Make sure that the door locks/unlocks and opens/closes properly.
Replace any damaged clips.
Front Door Latch Components and Components Location
Component Location 1. Front door latch ...

Front Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A). 3. Install in the reverse order of removal. ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: General Information


Lift And Support Points     When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting. When substantial weight is removed from the rear of the vehicle, ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Power Window Relay Repair procedures


Inspection Diagnosis With GDS 1. It can quickly diagnose defects of power window by communicating with GDS. GDS can operate actuator forcefully, monitor input/output values and self diagnose. 2. Select model and "BCM". 3. Select the "SJB" to check. 4. Select "Current Data" if yo ...

Copyright © www.ksoulev.com 2020-2025